Storm Door Chain Spring Stop Installation

The chain will be installed at two points by screws.
Storm door chain spring stop installation. The goal is to get the wind chain to stay in the space between your door closer and the top of your storm door. Install the s bracket parallel to the storm door with the single hole of the bracket pointing towards the hinge side of the storm door. If the door closer is mounted on the top of the door connect the chain to the storm door by inserting the end of the chain into the chain pin bracket at the end of the door closer and dropping the pin into. Because this chain door stop installs at the top of the door it may pose a problem as there is a bracket that must be attached to the top of the door with two 3 4 inch screws.
Item 1183626 model 632010. In no case is prime line responsible for user related damage or damage incurred during installation. Warranty is void if products are subjected to abnormal conditions misapplication. On the actual door you will need to take a measurement that will be a few inches off center on the top of the door frame to attach the retaining clip.
This side will retain the spring side of the door chain. 8 in steel screen door and storm door chain stop. Then install the hinge side z bar by drilling the hinges of the z bar onto the storm door s frame. Next cut the hinge side z bar to length and fit the storm door to the opening.
Spring and door chain retainer and mounting hardware. You are going to mount the other loop on the spring to the door jamb of your entry door. Pull the spring and the chain upwards and toward the hinge side of the door until the chain is as close to horizontal as you can get it. The first point is the direct center of the door opening on the frame of the door.
It appears that the retractable screen rolls up and is concealed in the top header of the door and if screws are going to be inserted there there is a good chance you.